Interesting Assignments!

It was just a glance that my final examination for my Delta 1^st Sem finished at 7^th of October. Before the test, we were so busy for our assignment and lab report because we do have a due date late and near to the final exam. One of the assignments is CAM lab report which it’s due date fall on 1 week before the final exam. I did the turning part which can be said that this assignment was my solo task. The note is thick and I need to do as much as the programming. This drags me to a worse situation since my preparation for final haven’t completed on time.

Nevertheless, the assignment is finally done and luckily my groupmate do help me compile it to a better looks package of a report. And one more thing that make me annoyed is that what I did for the assignment (turning) does not came out in the final exam and thus, what I did was just wasted. Instead, programming part came out an easier question that I can read and do easily.

My project is turning a shape of Sparkplug.

Bring to earlier time, that it was my Cad, “CATIA” assignment. It is using software to draw and I had tried it as hard as I am. Finally my groupmate and I were decreasing our level from drawing “Bicycle >> Water Tap >> Sink >> ”Recycle Rubbish Bin””

Dala~~ Here is my works, Recycle Rubbish Bin. We get 9 marks which is below the mean. Whatever, It can move uh huh~!

Again, milling lab which we using a milling machine which cost about MYR 60K, and the lab is equipped with mechanical computerized machine, one of it cost MYR300K. WOW!!

Baby MILO!

Well these assignments is quite interesting! Then I prepare for my final exam..